Latest videos by the70stang | Electronic Cigarette Videos

======================================
Try Ecigarette For FREE At http://tryecigarette.com
======================================

1970 Mustang Open headers Flyby
Posted by: the70stang

Video duration: 34 seconds

1970 Mustang Flyby just after reinstalling a '90 AOD.
351 Cleveland 2v
Edelbrock Intake and Carb
Headman Headers
Pertronix Electronic Ignition

Related: 1970, mustang, ford, flyby, open, headers, 289, 302, 351, cleveland, windsor, aod

Display Video Comments | Hide Video Comments | Add Comment

2 Stroke Motor Converted to Run on Air
Posted by: the70stang

Video duration: 35 seconds

This is a little 50cc 2 Stroke motor that I converted to run on air. I did so by using a solenoid to control when the air was released and a reed switch to control the timing of the solenoid. I never did get the timing down perfectly, but this was as close as I got.
I never meant for this to be a practical motor. Just a project to keep me busy.

Related: air motor, engine, 2 stroke, compressed air, reed switch, steam, conversion.

Display Video Comments | Hide Video Comments | Add Comment

Latest comments made on this video:

The air is provided ...
By: the70stang. on 27 May 12, 03:16:58
The air is provided by a compressor, so it's very inefficient as a? source of power, but it was never meant for that It was just a cheap project to keep me busy.

So what? runs the ...
By: Samsgarden. on 27 May 12, 02:02:49
So what? runs the air?

hey there, great ...
By: damononopium. on 03 Apr 12, 18:54:29
hey there, great work with the read switch! ? i'll try it this summer!

The on/off switch ...
By: the70stang. on 13 Mar 12, 20:15:53
The on/off switch controls when the circuit is getting power. The solenoid needed a certain amount of power to operate and then I had the reed switch wired in after the solenoid to act as a momentary switch that came on when the? magnets in the flywheel got close to it, which acted as a very crude timing system to make sure the pressurized air was release when the piston was at the top of its stroke.

for what you need ...
By: arnoldaszlt. on 13 Mar 12, 18:10:31
for what you need this switch and leads??

OUCH MY EARS?
By: crummyrex. on 26 Feb 12, 15:35:50
OUCH MY EARS?

There is absolutely ...
By: the70stang. on 09 Jan 12, 01:37:12
There is absolutely no point to this motor other than to see if I could do it. It takes energy to run, is extremely inefficient and lacks any form of useable power, and I have to spray WD-40 in it every time I run it, but it's different and I enjoyed making it. You've got some? good ideas and I think you should try them out instead of watching YouTube! Thanks for the comment! and I believe its spelled seize.

Nice piece of ...
By: magna59. on 08 Jan 12, 16:59:44
Nice piece of mechanical musing..but not sure of it's value, other than to keep you off the streets.Presumable you were generating the air pressure with a compressor,having to oil the air to get it to run and not sees (never thought to spell that word). If for example,it was a four stroke to avoid the problems of oil and? was on the other end of resevoir,filled by a wind powered generator .. few muse vitrification ..so may be good start.But then again, you've done it & i'm just fapping my lip!

I have seen it done ...
By: hammerogod. on 30 Oct 11, 08:51:09
I have seen it done of 4 strokes but I didn't think it could be? done on 2 strokes. Nice solution to an interesting set of engineering challenges.

Not sure which ...
By: the70stang. on 21 Apr 11, 17:26:47
Not sure which thingy your talking about? but the small thing that looks similar to a fuse that's wired above the flywheel is the reed switch.

cool was that ...
By: Mr3wheeledbike. on 20 Apr 11, 02:32:54
cool was that thingy the? reed switch

1970 Mustang with Open Headers
Posted by: the70stang

Video duration: 66 seconds

This is my 70 stang right after I finished bolting up the new headman headers. Luckily for me that is also right when my friend had lifts installed in his garage.
The engine is a 351C with an Edelbrock Performer Air Gap Intake, Edebrock 600CFM carb, Pertronix Electronic Ignition, and of course Headman Headers.

Related: open, headers, loud, 1970, ford, mustang, grande, uncorked, no, exhaust, 351, cleveland

Display Video Comments | Hide Video Comments | Add Comment

1970 Mustang with Spintech Exhaust
Posted by: the70stang

Video duration: 49 seconds

This is my Mustang with the new exhaust I just put on it. It has headman headers which go to two Spintech muffler which dump at the axle. Its loud as hell. I should have an open header video soon once my buddy gives me the file.

Related: 1970, mustang, exhaust, spintech, muffler, headers, headman, dual exhaust, muscle car

Display Video Comments | Hide Video Comments | Add Comment

1970 Mustang Exhaust
Posted by: the70stang

Video duration: 51 seconds

This is my 1970 Mustang with a 351 Cleveland in it. It also has a Performer Air Gap intake on it as well as true dual flowmaster super 40's with H-pipes. I might upload some donut videos if it rains up here again soon. I did my best to do some minor editing so let me know what you think. This is the same as my old video, youtube just disabled it for having Back in Black in it.

Related: 1970, mustang, ford, 351, 302, 429, exhaust, flowmaster, super 40s, dual exhaust, rev up, driveby, startup

Display Video Comments | Hide Video Comments | Add Comment

Electronic Cigarette Videos

Search

Electronic Cigarette Related Videos

Electronic Cigarette Sponsors